Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

agilent genesys question

Status
Not open for further replies.

biff44

Advanced Member level 6
Joined
Dec 24, 2004
Messages
5,048
Helped
1,376
Reputation
2,748
Reaction score
1,057
Trophy points
1,393
Location
New England, USA
Activity points
37,917
Lets say I have a 12 port in genesys. When I go to plot reflection coefficient of a port higher than "9", what do I type into the "graph properties" box for a smith chart. For example, if I want to see the reflection coefficient of port 11, what do I type? If I type S1111 I get and error message. If I type S11,11 I get another error message.
 

I'm no expert in genesys but did you try to right click on the port 11 and select New Graph S[11,11]
You could also try typing S[11,11] into graph properties.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top