Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Agilent ADS Optimization Question

Status
Not open for further replies.

sakeser

Newbie level 4
Joined
Nov 12, 2008
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,317
Hey everyone.

I am designing a circuit in ADS using modelithics models. I am doing a discrete optimization going through a list of SMT components to use and as I get better results, I'd like to be able traverse a list of previous opt results that were good and apply different opt goals on them to see which is best. I don't know how to generate a new list of previous opt results. Any suggestions?
 

sakeser

Newbie level 4
Joined
Nov 12, 2008
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,317
bump.

Anyone have any tips here?

I'd like to run simulations on a discrete list of values and essentially save the list of the parameters to be looked at later and choose one later.
 

amir88

Advanced Member level 4
Joined
Nov 4, 2009
Messages
118
Helped
13
Reputation
26
Reaction score
8
Trophy points
1,298
Location
bandarabbas
Activity points
1,926
I don't understand you clearly but if you want to optimize some componenet you can dclick on it and choose tune/opti/stat/DOE setup an in optimization tab choose disable or enable for specific component.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top