Advise for a PCB Diagnosis

[flote21]

Hello everybody,

I need to implement in my PCB design something to make a diagnosis of itself. For example, cheking power supplies, signal frequencies, temp sensors and so on. I would like to ask if some one can give me some adivises to monitroze or check this stuffs. I was thinking to use a CAN BUS or an OTG cable like the in the automotive industry. But I don't know how much complicated can be. If some have another ideas, I would be very grateful to listen to...

Note: My board has already a Cyclone IV and one PIC controller: 18F45XX.

Thanks.

 

[flote21]

Nobody has any advice??

Hello everybody,

I need to implement in my PCB design something to make a diagnosis of itself. For example, cheking power supplies, signal frequencies, temp sensors and so on. I would like to ask if some one can give me some adivises to monitroze or check this stuffs. I was thinking to use a CAN BUS or an OTG cable like the in the automotive industry. But I don't know how much complicated can be. If some have another ideas, I would be very grateful to listen to...

Note: My board has already a Cyclone IV and one PIC controller: 18F45XX.

Thanks.

 

[flote21]

I was thinking in other possibilities another posibility is the OBD2 system...