I've tried that but it still shows the error. The only workaround I can think of is if I use a value close to zero, i.e. 0.00000000001, but that changes the desired result for frequencies higher than 1GHz.
Warning detected by hpeesofsim in InitializePorts() during circuit set up.
Port TermG2 re(Z) <= 0, possibly due to extrapolation; setting re(Z)=0.001. So, re(Z) should be at least 0.001.
It will change the result because you're using pure inductive port that is unusual. Why it's so pure reactive ?
Is there any reason ?
Warning detected by hpeesofsim in InitializePorts() during circuit set up.
Port TermG2 re(Z) <= 0, possibly due to extrapolation; setting re(Z)=0.001. So, re(Z) should be at least 0.001.
It will change the result because you're using pure inductive port that is unusual. Why it's so pure reactive ?
Is there any reason ?
No, there's no particular reason for using that. I needed to match the ports and usually I use this port and haven't run into any problems yet. What other port can I use?
Also, the load without real part will not take energy out of the system. I'm afraid you abuse S-parameters here, consider using AC simulation with the appropriate source and load types.
Also, the load without real part will not take energy out of the system. I'm afraid you abuse S-parameters here, consider using AC simulation with the appropriate source and load types.
This is just an intermediate part. I will add another TL where the load is then I'll match it with a proper load. But before that i need to validate my theory.