Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

[SOLVED] ADS momentum, convergence problem

Status
Not open for further replies.

jkyriac

Newbie level 3
Newbie level 3
Joined
Mar 27, 2013
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,318
Hey guys, new here hope we can get along. I'm doing my theses on hyperthermia and was hoping you could help me. I'm designing an antenna on ads momentum, that has a superstrate
Here's a picture of the antenna

!2.jpg

here is what the layout looks like and their properties
layoutthickness(mm)ErtandMurtand
freespace
-----------
superstrate10600.001810
------- -STRIP - cond
substrate3.182.320.001210
////gnd////


here's the mesh I'm using

!3.jpg


The mesh is pretty dense so as not to have convergence problems and i didn't so far, but when i changed my antenna to alter its resonance frequency and changed the frequency range to be able to see it, momentum wouldn't converge (i think, it said "S parameters show unphysical values for certain frequencies")

I'm not entirely new to momentum I've designed antennas on it before, anyway can anyone help me out. [I read a post where someone had convergence problems with his transmission line and other people told him to check the transmission line mesh, what's it do?]

Thanks in advance
 

Attachments

  • !3.jpg
    !3.jpg
    164 KB · Views: 126
Last edited:

Hey dude, thanks for replying. I'm using a single mode port of Z=50Ω. And the version of the ads I'm using is 2009. But i think i resolved the problem by setting the mesh frequency from blank to twice the maximum frequency. (took a lot of time, like an hour or so, but it worked). Now I'd like to know if you can import a layout desing from ads to cst, know anything thanks in advance.;-)
 

You can also export your ads layout as gdsii and import in cst.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top