BilawalZia
Newbie level 2
hi!
I created a schematic and coverted that in a symbol and used that symbol in the second schematic.
then formed the second symbol for that schematic.
and in the third schematic(top level deign) i used that second symbol.
ADS gives the following error:
While evaluating expression `y1.X8.L2.L':expression has not been defined.
hope anyone can figure out the problem.
Thanks
I created a schematic and coverted that in a symbol and used that symbol in the second schematic.
then formed the second symbol for that schematic.
and in the third schematic(top level deign) i used that second symbol.
ADS gives the following error:
While evaluating expression `y1.X8.L2.L':expression has not been defined.
hope anyone can figure out the problem.
Thanks