Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

ADS Error: While evaluating expression `y1.X8.L2.L':expression has not been defined

Status
Not open for further replies.

BilawalZia

Newbie level 2
Joined
Jun 15, 2015
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
hi!

I created a schematic and coverted that in a symbol and used that symbol in the second schematic.

then formed the second symbol for that schematic.

and in the third schematic(top level deign) i used that second symbol.

ADS gives the following error:

While evaluating expression `y1.X8.L2.L':expression has not been defined.

hope anyone can figure out the problem.

Thanks
 

BilawalZia

Newbie level 2
Joined
Jun 15, 2015
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Yes there was a syntax mistake i figure out just now!

Thanks volker.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top