Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADS 2011 layout problem for Wilkinson Power Divider

Status
Not open for further replies.
K

kakar133

Member level 2
Member level 2
Joined
Sep 16, 2010
Messages
49
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
USA
Visit site
Activity points
1,579
Dear all,

I have design a wilkinson power divider in ADS2011. i am getting correct result for S parameters.
but the problem is with layout. I am not getting correct layout. please look at my layout and tell me what
is the problem. layout.png
 

no i have not connected the left side with the right side. it is generated by the ads. If i remove the resister then it gives correct layout,but without resistor it is not going to work please help me.
johnjoe said:
You connected the left side with the right side?!
Click to expand...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top