Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Adding practical "inductance" to probe feed port in IE3D

Status
Not open for further replies.
E

Er Swapnil Parihar

Newbie level 4
Newbie level 4
Joined
Jul 31, 2013
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
32
I have been designing a Radar planar antenna at low frequency. The height of the substrate is h=15mm. So the practical antenna is showing an added +34j (50 ohms matched value) inductance then the simulated results. To model this antenna correctly in software (IE3D) i need to add this inductance to port .....
How can i do that in software?? Please Please help:roll:
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top