Adding attenuation effect on signal in CST

Status
Not open for further replies.
K

kokolovehuh

Newbie level 1
Joined
Jul 18, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
9
Hi all,

I just started using CST and have some silly questions...

As title suggests, I am trying to apply an attenuation on an incoming signal from a port. Instead of drawing a 100m long coaxial cable I was wondering if there is an attenuator of some kind that does the same trick to attenuate the signal. Any thoughts?


Thanks alot!
 

You can add a shorter transmission line with higher losses by using a custom material with higher dielectric constant.
 

Use schematic symbols (in schematic view not 3d view) like resistors and model your attenuator and after this run em-simulation.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…