ADC10bit data only show 8bit data in hyperterminal

Hi All,

I am trying to measure the analog voltage in PIC16F877A. 10 bit data was used for ADC conversion. However, after transmission via serial port, it only shows 8bit data in hyperterminal. Please help

volatile unsigned int ADC_VALUE;

/* Selecting ADC channel */
ADCON0 = (ADC_Channel << 3) + 1;
ADIE = 0;
ADIF = 0;
ADRESL = 0;
ADRESH = 0;

ADGO = 1; /* Staring the ADC process */
while(!ADIF) continue; /* Wait for conversion complete */

ADC_VALUE = ADRESL; /* Getting HSB of CCP1 */
ADC_VALUE += (ADRESH << 8);
return (ADC_VALUE); /* Return the value of the ADC process */
}



void main(void)
{
OPTION=0xFF;
CLRWDT();
serial_setup();
InitialiseADC(0);

putst("\n\n\nInfra Red Distance Mesurement V0.1\n");
putst("Command List:\n");
putst("m - Measure Distance\n");
putst("Start... \n");
char getch_timeout_temp;
for(;
{
getch_timeout_temp=getch_timeout();
if (getch_timeout_temp=='m')
{
int Voltage = ReadADC(0);
putst("RESULT=");
putchdec(Voltage);
putst("\n\r");
}
}
}