ali shaheen
Junior Member level 1
- Joined
- Aug 29, 2010
- Messages
- 15
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- pakistan, karachi
- Activity points
- 1,419
hello
I am getting problem in implementing the condition on the data which is digitalized by ADC feature of PIC18f452 ...my code and the simulation of the project is attached with this thread....i actually just want to take the analog input(from RA2) and then want a condition on that If it raises to a specific voltage level the RB1 should start blinking and if either the voltage level decreases or increases from that level stop blinking the RB1 and start blinking RB2.....but its not working....:--(
please help.....
regards
ALI SHAHEEN
I am getting problem in implementing the condition on the data which is digitalized by ADC feature of PIC18f452 ...my code and the simulation of the project is attached with this thread....i actually just want to take the analog input(from RA2) and then want a condition on that If it raises to a specific voltage level the RB1 should start blinking and if either the voltage level decreases or increases from that level stop blinking the RB1 and start blinking RB2.....but its not working....:--(
please help.....
regards
ALI SHAHEEN