Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Now how to extend it is very much dependent on the code you have.
This also depends on your channel model, if this is path loss model, then you need to consider that fact as well.
For example: if there are two relays than at what distance they are:
from each other
from source
from destination
How much power each relay is allocated
I think, if you just share some outline of the code, it would be easy to extend it.
Otherwise, try to understand the code flowchart; what is going on ...
I am sure you can do it by yourself as well.
Now how to extend it is very much dependent on the code you have.
This also depends on your channel model, if this is path loss model, then you need to consider that fact as well.
For example: if there are two relays than at what distance they are:
from each other
from source
from destination
How much power each relay is allocated
I think, if you just share some outline of the code, it would be easy to extend it.
Otherwise, try to understand the code flowchart; what is going on ...
I am sure you can do it by yourself as well.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
