About the antenna switch ?

Status
Not open for further replies.
M

mckinson

Full Member level 2
Joined
Sep 3, 2003
Messages
126
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Activity points
1,034
Hello guys !
What maybe influence the attenuation of the antenna switch low pass filter ?The spec say the attenuation is 30db for 2nd harmonic and 3rd harmonic in normal .But in practical layout ,the attenuation is much lower than spec , what maybe decrease the attenuation ?
Best regards !
 

If you are taliking about a surface mount component, the common mistake is to use an insufficient number of ground vias or too much pad length to connect the device to ground, a break in the ground plane due to unwise board layout--causing ground loops, or some stray leakage path like through a bias line.
 

If my memory is correct, Their excisting harmonic generation specification in ASM which counts on small Power input where as large power input for harmonic attenuation as your saying.

Regards,
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…