About apr9600 voice module

[SINDHURI]

Good morning one and all,

i want to use apr9600 voice module to get the confirmation feedback command of the operated device. Is this module is able to connect wirelessly to the system to get feedback commands. Please clarify me is it possible or not.

Thank in advance.

 

[Jestin_cubetech]

please post a block diagram of your project.

 

[SINDHURI]

please post a block diagram of your project.

sir i have attached the data please check it.

Thanks in advance.

 

[Jestin_cubetech]

what do you meant by confirmation feedback command ?
can you specify this with an example?
attached document was incomplete.

 

[ec_nisarg]

as i can understand you want to ask some questions like "what color?" and arm should reply "it is black" am i right?

 

[SINDHURI]

as i can understand you want to ask some questions like "what color?" and arm should reply "it is black" am i right?

Good Evening Sir/Madam,

I am controlling the intensity of fan, as such i want to get the feedback as that at which level the fan is running,for that i am using this module. for example i am controlling the intensity of fan upto 4 levels ON,OFF,33% and 66%. for each level i have recorded a word in that module, after operating that level the module has to give the feedback confirmation that we are operating that module at that speed. For this operation, i want to know is this module is possible to connect wirelessly to ARM7 Microcontroller to get the feedback confirmation.

Thanks in Advance.

 

[ec_nisarg]

as per i know aplus ics are specially made for voice recording and playing it using pwm or ledder network. you have to attache a speaker to designated pins on it. and microphone too. it seem that this module has no interface to connect it to any micro controller. it can not send recorded data to micro controller. all you can do is trigger its record playback pins using micro controller. you can use separate rf trans receivers to communicate between uc and apr9600. but still you can send only playback commands not the entire voice file. you have to put an another micro at the end having apr9600 to receive commands, which will toggle pins according to your usage.