Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

about AP89010 voice ic

Status
Not open for further replies.
T

tej1200

Newbie level 3
Newbie level 3
Joined
Feb 26, 2014
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
32
I just noticed that the AP89010 has a VOUT1 and VOUT2 that can be hooked directly to speakers.
Then why an amplifier is needed when the AP89010 can directly drive the speakers ?
 

It is simple to use the spec's on the datasheet to calculate that its maximum output power into an 8 ohm speaker is EXTREMELY LOW at only 0.08W. About as loud as headphones laying on a chair. If you hold it in your hand in a quiet room then you might be able to hear its Chinese accent like on the sample sounds on its webpage. At the higher bandwidths it sounds very good but its memory lasts only for a few seconds.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top