Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

a problem of using starRC do extraction

Status
Not open for further replies.
Y

yifan_zhang

Newbie
Newbie level 2
Joined
Nov 10, 2010
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,292
when using starRC do extraction, I found that the port location presents after *|I (M2 ...) are not match the port on the layout, what is a possible issue caused this ?

Is there some setting i need to set ?

many thnaks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top