hi there, im a final year engineering student who is doing a project using the CAN protocol with the pic 18f548, i going to implement the network in C
i was wondring if any one have resources in C about programming CAN with 18f548
iv done that, however im going to have to do a network with 2 nodes, one is a heater connected to the pic then the can bus, the other is a step motor connected to a pic to the can bus, i must get the motor to work first, it is a four phase (A-B-C-D) unipolar type.
had any one got any information/code( C programs) that would be soo helpfull, i must get that node going first.