Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
When I simulate the following circuit with pspice, there is no frequency output in the antenna.
Is anything exist for replacing the antenna?
Would anyone know the solution?
I think that there may not need to care the antenna length in simulation mode.
My problem is no frequency waveform output when simulating.
Should there be insert some source (like VSIN) in the base of Q2 or other place?
A quarterwave "whip" monopole will have an input impedance of Zin = 36.5 + j21.25 ohms at it's resonant frequency. A half-wave dipole would be 70 ohms. You can replace your antenna with one of these two loads, depending on what type of antenna you intend to drive. It should work as a first-order approximation.
Still a transmitter needs a carrier waveform, if it's an AC analysis
you would need to figure out where to inject your reference tone
and if it's transient, give enough time & kick for the tank to ring up.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.