8 Layered PCB for PCB designers

Status
Not open for further replies.
T

taring77

Full Member level 2
Joined
May 20, 2004
Messages
144
Helped
2
Reputation
4
Reaction score
0
Trophy points
1,296
Activity points
1,330
www.pcbsoftwear.com

Hi all,
i have a 8 layered PCB to Convert from one software to another. there is about 15% of changes to the cct .
May i know what is the possible time line for this 8 layered PCB.
Major Components are :
289BGA (MCU) , 100pin TQFP (controller chip), 2x54pins TSSOP (RAM), 56 pin TSSOP (FLASH). Plus connectors n smallers cct.
Sch is about 8 pages in total.

Also all major part for schematic is to be created. The schematic also need to be converted.

So from anyone experience how long will it take?
PS: do include how long experience u have in this line..

thanks
 

Dear;

To convert PCB from tool to another
A- U can Convertion tool if it avilable.
B- Reroute the Bourd agin as flow:
1 - out the gerber file from the PCB
2 - create Packeg for U'r Component in new Software.
3 - convert the grber o DXF or any other format that U can input it as imege in the new PCB Softwear
4 - Convert Schmatic.
5 - load the net list and then route the new board exact as imege that U extract it from old PCB and inpuit it in new softwear.

it can tack about 2 week depend on tool and the PCB Engeneer that will work. I hoop that my help is in it's position as U want.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…