Anomis
Junior Member level 3
- Joined
- Mar 11, 2017
- Messages
- 29
- Helped
- 5
- Reputation
- 10
- Reaction score
- 4
- Trophy points
- 3
- Location
- South Korea
- Activity points
- 294
Hello my friends,
I am trying to drive a 350 watt,3phase, BLDC motor (DGW07-20j model) with stm32 micro controller. But I have problem with hall sensors because their outputs are not similar to the hall sensors which I have seen on the internet.
I connected the sensor supply to +5v dc (according to the sensor pcb guide). Then I connected two of hall sensor outputs (2of3) to the oscilloscope channels which is shown in the following picture.
Unfortunately, I couldn't find the model number of hall sensor or related data-sheet. But I connected the supply and outputs based on printed pinout guide on pcb. You can see these connections in this picture...
The motor was working while I captured the hall sensor outputs but clearly not not in a good way because the switching phase timing should be adjusted using hall sensor outputs.
I am trying to drive a 350 watt,3phase, BLDC motor (DGW07-20j model) with stm32 micro controller. But I have problem with hall sensors because their outputs are not similar to the hall sensors which I have seen on the internet.
I connected the sensor supply to +5v dc (according to the sensor pcb guide). Then I connected two of hall sensor outputs (2of3) to the oscilloscope channels which is shown in the following picture.
Unfortunately, I couldn't find the model number of hall sensor or related data-sheet. But I connected the supply and outputs based on printed pinout guide on pcb. You can see these connections in this picture...
The motor was working while I captured the hall sensor outputs but clearly not not in a good way because the switching phase timing should be adjusted using hall sensor outputs.