Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
R44 isn't necessary and R3 may need a slightly lower value but otherwise it should work.
Note that it may be advisable to add a snubber (33 Ohms and 100nF in series) across the triac MT1 and MT2 terminals in some circumstances, depending on the motor type.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.