<<20 Points >>

[m_3aziz]

if any one answers this Q i will pass him/her 20 points

i wanna know how to set the OFDM block that is already exist in Simulink ,how the range of frequencies is set and also the channel B.W (knowing that I wanna use 39 channels each of BW 5 MHZ around the 8 GHz frequency

I will be grateful for ur answers

 

[Communications_Engineer]

For frequency of 8GHz, your processor speed must at least be 16GHz. Practically, it must be around 20GHz.

Needless to you simulating at 8GHz carrier is not possible with a simple PC.

---------- Post added at 06:07 PM ---------- Previous post was at 06:05 PM ----------

oh yeah for the frequencies, you can set frequencies by converting the number of bins you are using into the Hz frequencies as kFs/N