Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

2 question about class-E power amplifier design

Status
Not open for further replies.
R

rezaee

Full Member level 2
Joined
Jul 3, 2009
Messages
129
Helped
4
Reputation
8
Reaction score
1
Trophy points
1,298
Activity points
2,117
what is the best input signal for class-E power amplifier?

mosfet in class-E power amplifier must act in off and triode region so how i can get this condition when source connect to ground and drain connect with RFC to 1.8v?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top