Your post implies that you don't have the basic knowledge of electronics.
This is a forum where people discuss problems with their projects/firmware, I seriously doubt that anyone will "contract build a project for you" free of charge. People on this board are much more responsive and are not seen flaming noob posts.
It would've been better had you posted the project that was mentioned in your post, along schematics and firmware and asked for advise from guys out here, it is not that difficult to expand 10x8 (or 8x8) with shift registers like H595, a combination/standalone of 2803/2891 etc some modifications (in fact a lot) to the code.
Then you could redo the layouts.