conmanxx
Newbie level 6
Hello
I need to clamp a millivolt signal from the output of a detector to 14mV.
The signal cannot exceed 14mV or it will trigger an alarm
Hoping to use a network of passive components perhaps.
Usually I'd use a clamping diode but that would be for something in the volts range. The signal max is so small I don't think it's possible.
Any ideas, I'm all out?!
I need to clamp a millivolt signal from the output of a detector to 14mV.
The signal cannot exceed 14mV or it will trigger an alarm
Hoping to use a network of passive components perhaps.
Usually I'd use a clamping diode but that would be for something in the volts range. The signal max is so small I don't think it's possible.
Any ideas, I'm all out?!
Last edited: