lm3524 inverter design
This thread is ridiculous.
you are asking for a schematic using a specific single channel pwm controller, yet you make no other demands, other than a 127 vac 60hz inverter.
furthermore the LM3524 doesn't have dead time control, so this isn't going to work for a high frequency pwm sin wave inverter.
that said, there is no reason to use it at all for a 60 hz center tap square wave inverter, the internal oscillator will not operate reliably below 1KHz as indicated by the theory of op in the datasheet.
if you wanted to synchronize the internal osc. to a 60hz trigger, you still have to deal with a 44% maximum duty cycle, and a nonlinear sawtooth waveform, not to mention the fact that you would be using the chip solely for the flip-flop and output driver, when you may need an external mosfet driver anyway