pcca
Junior Member level 3
Hello,
I need to test some delta sigma modulators.
I would like to ask how to convert a 1.8V single-ended clock to a 1.2V and 0.6V single-ended clock (on a PCB board). Is it possible?
If it is not possible, may your suggest a low-cost clock evaluation board with output clocks of 1.2V and 0.6V?
Kind regards,
I need to test some delta sigma modulators.
I would like to ask how to convert a 1.8V single-ended clock to a 1.2V and 0.6V single-ended clock (on a PCB board). Is it possible?
If it is not possible, may your suggest a low-cost clock evaluation board with output clocks of 1.2V and 0.6V?
Kind regards,