Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with WinPic800: ERROR >Written address0X00000

Status
Not open for further replies.
A

Al-Omrani

Newbie
Joined
Aug 7, 2006
Messages
4
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,283
Location
OMAN
Activity points
1,304
winpic800 problem

I have problem with WinPic800 .When I program 16F84A Pic in WinPin 800 display
ERROR >Written address0X00000
Written:0X3000 Read0X3FFF
What solution?
 

Re: Problem with WinPic800

PLS specify the programer tipe that u use
AND check if u constructed correctly the hardwere..
Regards LACI
 

Re: Problem with WinPic800

I use JDM programmer. And in hardware test display Hardware OK
 

Re: Problem with WinPic800

Yesterday , i had same problem.I'm afraid PIC is died :cry:
 

Re: Problem with WinPic800

did u`r device worked once....??
if yes u could have a defective pic....:(
try to think logicaly..;)
find the problem separate it in fix it
so...if u have a friend who has a programer try the pic if ok u have a problem whit the programer or soft if not u`r pic is defective ..:(
ir u`r problem is on the prgramer ican help u there..check &recheck triple check u`r schematic and pcb...
if u use jdm programer try ic prog it is easy to configure
select jdm programer in ic prog and select enable xp driver (if u use xp )
i will try to upload ic prog ifnot it is easy to find on internet
 

Problem with WinPic800

thank a lot, I have this problem
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top