Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can replace lead acid battery with similar capacity NIMH battery.
Vibration should not be a problem.
The only one thing you have to be aware of is that Ni-MH batteries can be damaged from heat due to overcharging, but this is easily avoided by using a high quality, microprocessor controlled battery charger or a charger designed for Ni-MH batteries and charging as directed by the manufacturer..
Regards,
IanP
Take care that the original way to recharge the lead acid batteries is not working properly with the NI-MH batteries too.
You risk to make an explosion due to surcharge of the batteries connected.
The recharging of the NI-MH batteries is something quite complicated, involving current, temperature, voltage and time.
If You are not recharging the batteries in your circuit I don't see any problem.
About vibrations, tested on one applicatoin until 8G random without any problem.
is lead acid sensitive to vibration? My brand new lead acid cell for a scooter went dead after 3 weeks. I recharge after every use and never discharged it completely.
Probably the only thing I would worry about is the charging. Make sure you use a NiMH charger, since the algorithm is different. This is really important, that the batteries be charged correctly.
Mixing old cells with new ones is always a bad idea, regardless of chemistry.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.