Anton89
Member level 3
Hello everyone,
In order to solve some mechanical issues, we want to route the microstrips of a RF board through internal metal planes.
We know that as general rule all RF signals must be routed on top metal plane with a underlying ground plane. Therefore, we do not know the consequence of a possibile routing through a internal metal plane, letting route the RF signal through a via-hole.
Do you have any advices about this topic?
Many thanks.
Regards,
Antonio
In order to solve some mechanical issues, we want to route the microstrips of a RF board through internal metal planes.
We know that as general rule all RF signals must be routed on top metal plane with a underlying ground plane. Therefore, we do not know the consequence of a possibile routing through a internal metal plane, letting route the RF signal through a via-hole.
Do you have any advices about this topic?
Many thanks.
Regards,
Antonio