adnan012
Advanced Member level 1
hi,
I want design boost inductor for PFC regulator. Here are the parameters
Input 85 to 250V
Out put 380 VDC
Fs 100kHz
Out put power 600 watts
I want to use Sendust CS508060 toroidal core. In some application notes, term NI (ampere-turn) is used against core AL value and in some notes L*i2 (mili-Henry*ampere Squared) is used against core Al value. What is the difference between these terms?
"Inductor design with DC bias" what does it mean?
regards
I want design boost inductor for PFC regulator. Here are the parameters
Input 85 to 250V
Out put 380 VDC
Fs 100kHz
Out put power 600 watts
I want to use Sendust CS508060 toroidal core. In some application notes, term NI (ampere-turn) is used against core AL value and in some notes L*i2 (mili-Henry*ampere Squared) is used against core Al value. What is the difference between these terms?
"Inductor design with DC bias" what does it mean?
regards