Bjtpower
Full Member level 5
Hello All,
i have designed the circuit as per the PI-EXPERT Software.
The circuit is working at no load giving Clean output of 27V
But when i am trying to Load say about 100mA, output voltage gets fluctuated continuously and it is not stable.
After Various trial and error, When i pulled down vpin to GND iT WORKED..!!
Now but the circuit is starting very small voltage and i want it to turn on at the 90VAC
Schematics is attached with the post.
I have tried the resistors till 3 mOHM From 4 mOHM but it is not working.
Pls guide where is the problem and how to avoid..??
Regards
Marx
i have designed the circuit as per the PI-EXPERT Software.
The circuit is working at no load giving Clean output of 27V
But when i am trying to Load say about 100mA, output voltage gets fluctuated continuously and it is not stable.
After Various trial and error, When i pulled down vpin to GND iT WORKED..!!
Now but the circuit is starting very small voltage and i want it to turn on at the 90VAC
Schematics is attached with the post.
I have tried the resistors till 3 mOHM From 4 mOHM but it is not working.
Pls guide where is the problem and how to avoid..??
Regards
Marx