Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Dsp nominal signal level ?

Status
Not open for further replies.
F

Fovakis

Member level 5
Joined
Nov 15, 2012
Messages
88
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Greece,Athens
Activity points
2,028
Hi i have a question about the minimum and maximum voltage level that my DSP receiver must take. So i have a wireless system with one transmitter constiting of mixers lna l.o sending data to a receiver that is like tha attached image. The dsp reveiver take a signal that is downoconverting to 10khz around...
https://i1284.photobucket.com/albums/a578/fovos1/receiver_zps50361020.png

I have read (don't know if it is right) that the DSP's input is a line in with impedance is typically around 10KΩ.

Also the nominal signal level at DSP input must be around 1 volt peak to peak. So what is this ? if i give 0.1 volt the DSP will not work? if i give 2 volt what?

i send an jpg data of bandwidth 14Khz.My DSPtransmitter is TMS 3220 C6416 DSK and the receiver is TMS 3220 C6713 DSK

tHANs :)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top