Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

VPCM generates Transformer model. How could do the LVS using calibre?

Status
Not open for further replies.
W

wccheng

Full Member level 5
Joined
May 16, 2004
Messages
287
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Activity points
2,710
Dear all,

I have tried to use VPCM to generate the transformer model. However, I don't know how could I do the LVS using Calibre. Could anyone teach me?

Thanks

wccheng
 

VPCM is a software provided by C@dence. However, it is available in mmsim7.1. This software is unavailable after mmsim 7.2 or higher.
 

wccheng said:
"VPCM" is a software provided by C@dence. However, it is available in mmsim7.1.
This software is unavailable after mmsim 7.2 or higher.
Click to expand...
Not correct. Currently it is not called as VPCM(Virtuoso Passive Component Modeler).
Current correct name is VPCD(Virtuoso Passive Component Designer).

Always describe correct name without using any abbreviation.
The Designer's Guide Community Forum - Cadence VPCD is EOL ?
https://www.edaboard.com/threads/205843/

wccheng said:
I have tried to use VPCM to generate the transformer model.
However, I don't know how could I do the LVS using Calibre.
Click to expand...
Add a layer for identification of inductor, then add rule file for Mentor Calibre.

"Transformer" is a "coupling inductors".
https://www.edaboard.com/threads/208710/

If you use Cadence Assura, no additional work is required for LVS.
The Designer's Guide Community Forum - Basic Inductor modeling question
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top