Mabrok
Full Member level 4
Hi,
In ADS load pull simulation results. Is it correct that the impedance at marker 3 is the Zload (7.161+j 2.480) which are using in output matching design, and input impedance is the Zsource (16.97-j 32.31) using in input matching network design? And also want to know is it one tone load pull is sufficient for design high efficiency RF power amplifier (i.e. no need to perform 2 tone load pull)?
I already attached my results from load pull simulation (One tone load pull with constant source power). Thanks in advanced
In ADS load pull simulation results. Is it correct that the impedance at marker 3 is the Zload (7.161+j 2.480) which are using in output matching design, and input impedance is the Zsource (16.97-j 32.31) using in input matching network design? And also want to know is it one tone load pull is sufficient for design high efficiency RF power amplifier (i.e. no need to perform 2 tone load pull)?
I already attached my results from load pull simulation (One tone load pull with constant source power). Thanks in advanced