msdarvishi
Full Member level 4
Dear all,
I have a block design targeting a ZCU106 board.
I have used the Zynq UltraScale+ MPSoC to realize the Processing System and XDMA Bridge to PCI Express to implement PCIe.
I put a DDR4 SDRAM in the block design which is the DDR4_PL and I would like to allocate 2GB of memory to it. But I see in the Address Editor tab, that the maximum allowed memory cannot go beyond 512MB in the best case. Please see the attached photo of Address Editor. As you see, this DDR4_PL is ONLY seen by PCIe.
Can anoyonehelp me to overcome this problem and extend the DDR4_PL memory size?
Thanks in advance for your support.
Bests,
Daryon
I have a block design targeting a ZCU106 board.
I have used the Zynq UltraScale+ MPSoC to realize the Processing System and XDMA Bridge to PCI Express to implement PCIe.
I put a DDR4 SDRAM in the block design which is the DDR4_PL and I would like to allocate 2GB of memory to it. But I see in the Address Editor tab, that the maximum allowed memory cannot go beyond 512MB in the best case. Please see the attached photo of Address Editor. As you see, this DDR4_PL is ONLY seen by PCIe.
Can anoyonehelp me to overcome this problem and extend the DDR4_PL memory size?
Thanks in advance for your support.
Bests,
Daryon