Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

measuring opamp parameters

Status
Not open for further replies.
S

sabu

Junior Member level 3
Joined
Sep 20, 2005
Messages
31
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,517
hi friends,
i am eager to know how i can measure slew rate,CMRR,and power consumption of opamp while simulating the ckt in TSPICE, i am waiting 4 ur help
thanking u
sabu
 

For Slew Rate, wire a -1 configuration and put a squared signal in the input. Then at one transition measure ΔVo= Vmax - Vmin, and Δt= tfinal -tinitial.

SR = ΔV/Δt

Added after 4 minutes:

FOr CMRR Ad/ Ac


At open loop put a dirferential signal very small like a sinusoidal one, reduce until you don't have any distortion at output, Ad = Vo/Vi.


Ac = Vo/Vi but the same signal at both inputs, here you must increase Vi until you can get a signal at putput.


FOr Power I don't know yous simulator but you must use a Wattmeter and measure Power in every device, and add all.
 

Pls reference to the chapter 6 of "CMOS Analog Circuit Design", maybe u will get the solution!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top