taring77
Full Member level 2
PADs CAM
Hi all i need to know if PADs can do this,
Lets say i have a net to route in 4 layer board.
It goes from Layer 1 to Layer 4, meaning the traces DO NOT run in layer 2 or 3.
When u cam u will see a dot in layer 2 & Layer 3 with no connectivity.
So how is it possible to remove the 'dots'/ via in layer 2 & 3.
other then using Cam TOOLs
tHANKS aLL
Hi all i need to know if PADs can do this,
Lets say i have a net to route in 4 layer board.
It goes from Layer 1 to Layer 4, meaning the traces DO NOT run in layer 2 or 3.
When u cam u will see a dot in layer 2 & Layer 3 with no connectivity.
So how is it possible to remove the 'dots'/ via in layer 2 & 3.
other then using Cam TOOLs
tHANKS aLL