T
treez
Guest
On page 9 of the book “Power supply design, Volume 1 Control” by Dr Ridley, he states that a Full Bridge converter is good for power levels from 200w to over 5000w.
Most places where I have worked would usually say above 1000W means a resonant converter is really needed.
If anything, it is said that this is because the noise of a hard switched converter at above 1000W could disrupt the signal circuitry in the control section, and stop the power supply from operating properly.
Is Dr Ridley a little wide of the mark, or not.?
Most places where I have worked would usually say above 1000W means a resonant converter is really needed.
If anything, it is said that this is because the noise of a hard switched converter at above 1000W could disrupt the signal circuitry in the control section, and stop the power supply from operating properly.
Is Dr Ridley a little wide of the mark, or not.?