Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Why a design works in SpectreS but not in Spectre?

Status
Not open for further replies.
K

kamesh419

Member level 1
Joined
Feb 11, 2005
Messages
37
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
426
Spectre error

Dear all,

I am trying to simulate a design. All works well with "spectreS"
simulator, but when it comes to "spectre" then I get an error.

Error found by spectre during circuit read-in.
"input.scs" 8: Unable to open library file
`/opt/eda/xfab/spectre/xc06/xc06.scs'.
No such file or directory.

spectre terminated prematurely due to fatal error.
Click to expand...

I am using XFAB 0.6u technology and the folder xc06 corresponds to
that. I have checked that the library file xc06.scs file indeed does
not exist.

Why is it that it works well with "spectreS" and not with "spectre".
How could i make my design work for "spectre"? I am new to cadence.

Thanks in advance,
Kamesh
 

Re: Spectre error

did u check if your libraries are loaded or not ?
 

Spectre error

Hi mmohsen,

Yeah my libraries are loaded.

I have just checked out the documentaion for X-fab. It has a link to X-FAB supported Design Programs. Here is the link to the screenshot.

httpp://www.aisl.cyd.liu.se/temp/screen.jpg

Unfortunately "spectre" is no where to be found there. But i could find "spectreS". So i guess i have to work with spectreS. Any other suggestions ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top