Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Network analyzer calibration for RF test points

Status
Not open for further replies.

Anton89

Member level 3
Joined
Apr 12, 2015
Messages
56
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
631
Hello everyone,

I have used some RF test points to characterize the RF components of a S-band receiver prototype. The part numbers are: MS-156C3 for the RF test points; MS-156-HRMJ-H1 for the plug (the mate-connector).

Since I would like to measure the S-parameters, I need to use a calibration kit for the network analyzer.
My question is:

Is avaliable on the market a calibration kit for the MS-156-HRMJ-H1 connector?

Many thanks.
Yours sincerely,
Antonio
 

What the intended accuracy (delay, Z0)? MS-156C itself has limited precision, see e.g. VSWR spec.

Did you consider to make your own calibration kit?
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top