sjaikumar
Newbie
Hi,
I have a MCP6002 wired as a buffer circuit. A voltage divider with 1M and 20K to ground. When i feed the voltage divider output to input of the buffer. The output voltage of the Buffer
when measured is off by few milli volts, and it changes at various voltages of the input.
The input voltage was always well below the max Supply voltage of the opamp which is 5V.
any help would be appreciated.
Thanks,
Jai.
I have a MCP6002 wired as a buffer circuit. A voltage divider with 1M and 20K to ground. When i feed the voltage divider output to input of the buffer. The output voltage of the Buffer
when measured is off by few milli volts, and it changes at various voltages of the input.
The input voltage was always well below the max Supply voltage of the opamp which is 5V.
any help would be appreciated.
Thanks,
Jai.