circuitking
Full Member level 5
Hi, for the attached stack structures I already added the capacitors after doing simplifications. I was thinking I should multiply the capacitance with the resistances I marked.
1. Is it correct, the resistance at nodes I marked as 1/gm?
2.How would I find the bandwidth from these pole frequencies (for both circuits)?
3. The input pole give me lower cutoff frequency and output pole give me higher cutoff frequency?
4.Can I already now without actually plugging in the actual values which are dominant poles?
1. Is it correct, the resistance at nodes I marked as 1/gm?
2.How would I find the bandwidth from these pole frequencies (for both circuits)?
3. The input pole give me lower cutoff frequency and output pole give me higher cutoff frequency?
4.Can I already now without actually plugging in the actual values which are dominant poles?