+ Post New Thread
Results 1 to 5 of 5
  1. #1
    Advanced Member level 5
    Points: 32,938, Level: 44
    Achievements:
    7 years registered

    Join Date
    Sep 2008
    Location
    cambridge
    Posts
    6,853
    Helped
    496 / 496
    Points
    32,938
    Level
    44

    Thermal vias in pads..plated over

    Hi,
    Our PCB manufacturer offers us thermal vias in dpak pads, and plated over on top and bottom sides. They are filled with epoxy.
    How come the air that must get trapped inside them doesnt get hot and explode out?

    •   AltAdvertisement

        
       

  2. #2
    Super Moderator
    Points: 260,224, Level: 100
    Awards:
    1st Helpful Member

    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    45,441
    Helped
    13826 / 13826
    Points
    260,224
    Level
    100

    Re: Thermal vias in pads..plated over

    The epoxy fill is free of voids.


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  3. #3
    Advanced Member level 5
    Points: 12,693, Level: 27
    Achievements:
    7 years registered

    Join Date
    Feb 2010
    Location
    UNITED KINGDOM
    Posts
    1,985
    Helped
    619 / 619
    Points
    12,693
    Level
    27

    Re: Thermal vias in pads..plated over

    Don't fill them, its cheaper.


    1 members found this post helpful.

    •   AltAdvertisement

        
       

  4. #4
    Super Moderator
    Points: 260,224, Level: 100
    Awards:
    1st Helpful Member

    Join Date
    Jan 2008
    Location
    Bochum, Germany
    Posts
    45,441
    Helped
    13826 / 13826
    Points
    260,224
    Level
    100

    Re: Thermal vias in pads..plated over

    Don't fill them, its cheaper.
    Fill and overplating are related. You can't have VIPPO without fill. The question is if VIPPO (the most expensive thermal via option) is actually required or standard open thermal via serves the purpose.


    1 members found this post helpful.

  5. #5
    Advanced Member level 5
    Points: 12,693, Level: 27
    Achievements:
    7 years registered

    Join Date
    Feb 2010
    Location
    UNITED KINGDOM
    Posts
    1,985
    Helped
    619 / 619
    Points
    12,693
    Level
    27

    Re: Thermal vias in pads..plated over

    On critical jobs I have the plating done thicker, 0.035-0.050mm plating in the via... Generally mil/aerospace jobs, cheaper than plating.


    1 members found this post helpful.

--[[ ]]--