brokewoodworker
Newbie level 3
Can someone identify the component at the end of the grey wire? The little resistor looking piece attached to the white rectangular PCB.
I accidentally smashed it while attempting to fit the components into the plastic housing after replacing the brushes, and now whenever the switch is depressed, my lights dim and the motor stalls.
It is also housed approx 5" from the main board, so I'm assuming it has something to do with heat management.
It is part of the electronic speed control module from a variable speed jigsaw.
It looks like a 4.7kohm resistor but replacing it with a new one did not fix the issue.
Specific part number:1607233559
https://www.ereplacementparts.com/electronic-speed-control-p-1117953.html
Thanks for the suggestions.
I accidentally smashed it while attempting to fit the components into the plastic housing after replacing the brushes, and now whenever the switch is depressed, my lights dim and the motor stalls.
It is also housed approx 5" from the main board, so I'm assuming it has something to do with heat management.
It is part of the electronic speed control module from a variable speed jigsaw.
It looks like a 4.7kohm resistor but replacing it with a new one did not fix the issue.
Specific part number:1607233559
https://www.ereplacementparts.com/electronic-speed-control-p-1117953.html
Thanks for the suggestions.