abimann
Member level 4
I use XC4VLX100 , used buffers for HDMI output OBUFDS/OBUFTDS, in UG070.PDF said Virtex-4 can use IOSTANDARD LVDS_25, LVDSEXT_25, ULVDS_25,
I used all of them but cannot pass implementation stage in ISE, but board used 3.3V only, it mean chip can check voltage ? and if I use external 2.5 V it must work ?
board designers guid :
Please note that you must use I/O standard “LVCMOS33” or “LVTTL”, when IO voltage is 3.3V. If you need to use other I/O standard, then, cut away J6 and J7, and connect external I/O voltage
ISE says :
ERRORack:1107 - Pack was unable to combine the symbols listed below into a
single IOBS component because the site type selected is not compatible.
I used all of them but cannot pass implementation stage in ISE, but board used 3.3V only, it mean chip can check voltage ? and if I use external 2.5 V it must work ?
board designers guid :
Please note that you must use I/O standard “LVCMOS33” or “LVTTL”, when IO voltage is 3.3V. If you need to use other I/O standard, then, cut away J6 and J7, and connect external I/O voltage
ISE says :
ERRORack:1107 - Pack was unable to combine the symbols listed below into a
single IOBS component because the site type selected is not compatible.
Last edited: