eepty
Full Member level 2
I am developing a project which is related to detection of the hand movement when the users are using a product. In the device there is micro-controller and a 6-DOF IMU (accelerometer and gyroscope) for this purpose.
I am planing to create a firmware on the micro-controller which will output the data from the IMU through serial communication and the data will be stored in a spreadsheet in the computer. Then I will ask the users to use the product normally so that I have the user data during normal usage. After that I will try to test the hand movement detection algorithm in a computer simulation software to verify the algorithm. At last I will implement these algorithm into the micro-controller. Is this process good?
Can you recommend any computer simulation software that could do the job? Prefer to have one with cheaper cost
Thank you very much.
I am planing to create a firmware on the micro-controller which will output the data from the IMU through serial communication and the data will be stored in a spreadsheet in the computer. Then I will ask the users to use the product normally so that I have the user data during normal usage. After that I will try to test the hand movement detection algorithm in a computer simulation software to verify the algorithm. At last I will implement these algorithm into the micro-controller. Is this process good?
Can you recommend any computer simulation software that could do the job? Prefer to have one with cheaper cost
Thank you very much.