yuyee
Junior Member level 2
Hi,
I was confused on SP2T switch(0-8ghz) in RF circuit. And my frequency signal is from 2ghz-3ghz.
Would like to know whether a bandpass filter is needed to remove the unwanted frequency ?
Will there be other factor arise if BPF is implemented?
Pls advise. Thanks
Regards,
yuyee
I was confused on SP2T switch(0-8ghz) in RF circuit. And my frequency signal is from 2ghz-3ghz.
Would like to know whether a bandpass filter is needed to remove the unwanted frequency ?
Will there be other factor arise if BPF is implemented?
Pls advise. Thanks
Regards,
yuyee