Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem with cd4013 Flip Flop startup state

Status
Not open for further replies.
E

Em_13

Junior Member level 3
Joined
Feb 7, 2016
Messages
28
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
232
Hi,I have built a simple toggle switch with 4013 common dual flip-flop ic.The toggle buttons work fine,so Everything is ok except primary state of output.The output (PIN 1 & 13)state is high when I connect Vcc to circuit despite the inputs are on low state .What should I do to keep output in low state when connect VCC to circuit ?


4013 flip flop.JPG​
 

Hi,

You need a power up reset circuit.
Depending on rise time of power supply you either need a more complicated reset generator with dedicated threshold voltage and reset timing.
In simple case (fast power supply rise time) a capacitor across one pushbutton may be sufficient.

Klaus
 
  • Like
Reactions: Em_13

    E

    Em_13

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top